Mechanical Engineering · Free tool

CNC and post-process surface finishes

A reference for anodising (Type II and III), Alodine, black oxide, powder coat, plating and heat treatments, with thickness and design tips.

Black faceted enclosures with a consistent satin finish and a green status light.
A finish has to hold up across a family, not only on one look-like render.

A machined or formed metal part is not finished when it leaves the mill. The surface finish — anodising, conversion coating, plating, powder coat, or a heat treatment that also changes colour and hardness — decides corrosion behaviour, wear, electrical contact, and how the part will look in five years. This reference covers the finishes mechanical designers specify most often, with compatible materials, typical thickness, and design notes.

Type II (sulphuric) anodising is the everyday cosmetic and corrosion finish on aluminium; Type III (hardcoat) is thicker and harder, used for wear. Thickness eats into tolerance and sharp edges can chip, so drawings should say whether dimensions are before or after finish. Alodine (chromate conversion, with restrictions and alternatives depending on region and RoHS/REACH) is a thin conductive conversion coat, often used under paint or where electrical contact matters. Black oxide on steel is thin and mainly cosmetic or a mild rust delay, not a substitute for a real coating in a harsh environment.

Powder coat and wet paint hide machining marks and can fill a class of cosmetic defects, at the cost of thickness variation and the need for a clean, designed edge. Plating (zinc, nickel, and others) has its own hydrogen-embrittlement and masking stories. Heat treatments — through-hardening, case hardening, tempering, and precipitation ageing — are not “colours”, but they belong in the same conversation because they change dimensions and sometimes appearance.

Always write the finish on the drawing with a standard or a vendor code, the thickness range, the surfaces that must be masked, and the datum dimensions that are before or after finish. This reference is a map, not a process specification.

Example

A callout worth writing down. “6061-T6 aluminium housing. Type II anodise, black, 12–18 µm, after machining. Dimensions apply after finish unless marked. Mask the internal M3 thread and the 6 mm ground pad.” That one block prevents a surprising fit and a painted electrical contact. The reference is there so you remember to write it.

How to use this tool

  1. Open Surface Finishes and find the finish you are considering, or start from the base metal.
  2. Check compatibility, typical thickness, and whether the finish is cosmetic, protective, or functional (wear, contact).
  3. Decide which dimensions are before finish and which are after, and mark masking if holes or contact faces must stay bare.
  4. Add the finish callout and thickness to the drawing before you release it for quote.
  5. Ask the finisher about rack marks, colour variation, and any bake or embrittlement relief the process needs.

Frequently asked questions

What is the difference between Type II and Type III anodising?

Type II is conventional sulphuric anodising, typically thinner and used for corrosion resistance and colour. Type III is hard anodising: thicker, harder, more wear-resistant, and more hungry for dimensional allowance. Confirm thickness and colour with the finisher.

Does anodising insulate aluminium?

The anodic layer is an oxide and is electrically insulating where it is present. If you need a ground path, mask a contact pad or use a conversion coat instead on that face.

Is black oxide enough rust protection for outdoor steel?

Usually no. Black oxide is thin. Outdoor or wet environments generally want a plating, a paint or powder system, or a stainless alloy — specified for the environment, not for the colour alone.

Should heat treatment come before or after machining?

It depends on the process and the tolerances. Hardening can move a part; sometimes you rough, heat-treat, then finish-machine. Agree the sequence with the shop and put it on the drawing.