Mechanical Engineering · Free tool

Tolerance stack calculator (worst-case and RSS)

Add parts and compute worst-case and RSS (root-sum-squared) tolerance stacks for linear assemblies. Free mechanical calculator on brahm.design.

Engineers reviewing a CAD model on a monitor next to a physical part on the desk.
A stack-up is easier to trust when the CAD and the part are on the same table.

A drawing can look fine part by part and still fail as an assembly. A tolerance stack is how you add the dimensions and tolerances that sit in a loop — a gap, a flush condition, a travel — and see whether the result is still acceptable. This calculator lets you add parts with a nominal and a plus/minus, then computes a worst-case stack and an RSS (root-sum-squared) stack for a linear assembly.

Worst-case is simple and conservative: you add the upper limits in the direction that hurts, and the lower limits in the other direction. If the assembly still works at worst case, you have a strong argument. It can also force tolerances that no process can hold at a sensible cost. RSS treats the tolerances as independent and roughly normal, and uses the square root of the sum of squares. It is a statistical estimate, often discussed around a high (roughly three-sigma) yield, not a guarantee of every unit.

Use worst-case for safety, sealing, or very short stacks. Use RSS with care when the loop has many contributors, the processes are in statistical control, and a small yield loss is acceptable. Do not mix unit systems, and do not forget finish thickness, gasket crush, and thermal growth if they sit in the same loop — the calculator will only add what you enter.

The toolkit also lists typical process capabilities so you can sanity-check a tolerance before you put ±0.02 mm on an as-moulded rib. A number the process cannot hold is not a specification; it is a future concession.

Key relationship

Worst-case: T_wc = Σ t_i (signs taken in the harmful direction).
RSS: T_rss = √(Σ t_i²), with t_i the relevant bilateral (or the larger unilateral) contribution of each part.

Try a linear worst-case and RSS stack

Three contributors, in millimetres. Open the toolkit for a longer assembly, process notes, and the rest of the ME tools — no account needed.

Worst-case adds the tolerances; RSS is √(Σt²). This preview assumes a simple adding loop. Sketch the signs on paper first.

How to use this tool

  1. Sketch the loop on paper first: which dimensions add, which subtract, and what gap or flush you care about.
  2. Open the Tolerance Stack tool and add each contributor with its nominal and plus/minus.
  3. Compute worst-case. If it already works, you are often done for a short loop.
  4. Read the RSS result as a statistical estimate, not as a promise. Check whether your process is stable enough to justify it.
  5. If the stack fails, decide whether to move a nominal, tighten a process, or add an adjustment — do not only shrink every tolerance by half.

Frequently asked questions

What does RSS assume?

That contributors are independent and that variation is reasonably modelled as a normal distribution. Those assumptions fail if one process dominates, if parts are matched or biased, or if you only ever inspect a few pieces.

Should I design to worst-case or RSS?

Design to the function. Safety and sealing usually want worst-case or a clearly argued method from your company standard. High-volume consumer stacks often use a statistical method with a stated yield target.

Can I model 3D or geometrical stacks?

This calculator is for linear, plus/minus loops. Geometrical stacks (position, profile, datum shift) need a 3D analysis or a careful manual method. Use the GD&T reference for the symbols, then a proper stack tool or a spreadsheet you trust.

Do temperatures belong in the stack?

If the assembly sees a temperature range and the materials differ, yes — as extra contributors, not as a hope. The calculator will not invent them for you.