Electronics / PCB · Free tool

PCB and hardware interview simulator

Practise PCB and hardware interviews for Apple, Nvidia, Qualcomm, Tesla Hardware, Medtronic and more. Timed questions, free on brahm.design.

An engineer assembling IoT controllers at a bench covered with boards, housings and a tablet.
Hardware interviews go better when you can talk about a board you have actually built.

Hardware interviews for PCB and electronics roles move quickly between schematic judgement, layout rules, and how you debug a board on the bench. The PCB interview simulator is a timed practice tool with company cards across consumer hardware, semiconductors, EV and power, aerospace, medical and robotics — including teams such as Apple, Nvidia, Qualcomm, Tesla Hardware and Medtronic, among others.

The point of picking a company is the emphasis. A consumer-device interviewer may care about stackup, DFM, and bringing up a first article. A semiconductor or RF interview may lean on signal integrity and return paths. A medical or automotive conversation will bring up reliability, creepage and documentation. Practising that shift is more useful than memorising a single bank of trivia.

Answer out loud, and when the question is about a circuit or a stack, sketch it. A good answer names the rule or the standard you would check (for example a clearance from IPC-2221, a decoupling practice, or a measurement you would actually make), not only a slogan like “add more vias.” The debrief is for finding the thin area — layout, power, EMC, or process — and going to study it in the rest of this toolkit.

This is rehearsal, not a leaked question set. Combine it with a real schematic review, a board you have brought up, and the homework you should do on the company’s products.

Example

A solid short answer. “Where do you put the return via for a decoupling capacitor on a four-layer board?” A useful answer talks about a tight loop, vias close to the cap pads, the reference plane, and what changes if the cap is for a switching node versus a quiet analog rail. The simulator is there so you can get to that level of specificity under time.

How to use this tool

  1. Open the PCB toolkit and start the Interview Simulator.
  2. Pick a company close to the role and read the short style note.
  3. Start the timer. Sketch stacks, return paths and decoupling when the question needs it.
  4. Name the standard or the measurement you would use, not only the instinct.
  5. Use the debrief to choose the next topic in the toolkit — trace width, DRC, schematic or stackup.

Frequently asked questions

Is this only for PCB layout engineers?

No. The questions are useful for board design, hardware design and embedded engineers who still own a schematic and a bring-up. Firmware-only interviews will need other practice as well.

Do you cover RF and high-speed digital?

Those themes appear, especially around stackup, return path and decoupling. Deep RF or serdes work still needs specialist study beyond a general hardware bank.

Can I practise calculation questions here?

You will get some quantitative prompts. For a dedicated current-capacity calculation, use the IPC-2221 trace width calculator in the same toolkit.

Is it free?

Yes, with a free brahm.design account.